| The proper application of a hair replacement system | | | | becomes second nature. |
| is very important. If the system isn’t properly | | | | If you’re using a full head bond you are probably |
| place the hair wearer may find the system | | | | using an adhesive so your preparation will be slightly |
| uncomfortable and un-Styleable. | | | | different. Again, it is important to have system, hair |
| First it is important to have all your products readily | | | | and scalp completely clean and free from dirt and |
| at hand and of course a mirror will be necessary. Be | | | | oil. It is particularly important to prepare the scalp |
| sure that your system as well as your scalp is | | | | utilizing a scalp cleaner and scalp prep. The cleaner |
| absolutely clean and free from dirt and oil and both | | | | has an astringent value that will close the pores and |
| your head and system should be dry. For the | | | | the scalp prep will coat the skin on the scalp to keep |
| benefit of your skin it is recommended that you | | | | potential bacteria from making it’s way into the |
| apply a skin cleaner to remove any additional oil on | | | | skin. If you’re wearing a skin system, wipe the |
| the scalp and if available apply a thin layer of Scalp | | | | base with 99% alcohol and allow to completely dry. |
| Prep to protect your scalp after the system is on. | | | | Once the base is dry apply a thin layer of your |
| If you’re wearing a tape on system, wipe the | | | | adhesive and allow the adhesive to get slightly |
| tape tab area with some 99% alcohol to assure | | | | tacky. Apply a thin layer of adhesive to your scalp |
| there is no residue or oil on the tape tab area. | | | | and also allow the adhesive to get slightly tacky. |
| Apply your tape, lifting the liner in areas where | | | | Once the scalp and base are ready follow the |
| you’re overlapping strips. Once your tape is in | | | | directions above for applying the system. It is very |
| place remove the liner. Have your existing hair clean | | | | important with a full head bond to do this procedure |
| dry and styled then pick up your system holding the | | | | correctly the first time. As you roll the system back |
| front towards you with the back away from you | | | | onto your scalp press is gently down to eliminate any |
| and have the base inverted. Inverting the base will | | | | bubbles or wrinkles. Once you have the system on |
| keep the hair from getting on the tape. Locate the | | | | and in place gently press the entire system allowing |
| center front of you hair line and gently place the | | | | the adhesive on the base and scalp to bond |
| front of the system at this point then gently roll the | | | | together. If you’re doing a full head bond with |
| system back into place on your scalp. Check your | | | | lace, follow the same procedure only eliminate putting |
| placement and if your happy with it press the tape | | | | the adhesive on the base of the system and apply |
| onto your scalp. If you find you are a little crooked | | | | two thin layers of the adhesive to the scalp allowing |
| with your placement gently pull the system off going | | | | the first to dry before applying the second layer and |
| from back to front, readjust the placement and | | | | letting the second layer get tacky, then apply the |
| repeat the procedure. Once the system is in place | | | | lace system to the head in the same manner as the |
| style the hair into your existing hair and you should | | | | skin. |
| be ready to go. After a few tries this action | | | | |
