| If the source of the techniques of hair often goes | | | | of the hot tongs about 2.5 to 4 cm. There are larger |
| back to the dawn of time, it was not until the end of | | | | plates, but these are necessary only for even longer |
| the century to see the development of thermal | | | | hair. For medium hair, small plates have the advantage |
| techniques,. Later, Thermal brushes and straightening | | | | of being more controllable, more lighter and easier to |
| irons were used to straighten naturally wavy hair. | | | | handle. |
| These techniques were effective, but much | | | | Three: Work with locks maneuverable and do not |
| damaged hair. | | | | use more of the heat needed. Many women wear |
| Fortunately, science continues to advance. | | | | plates and complain that they do not work well. |
| Today, special thermal units, designed to change the | | | | Often, because they use too. If you try too many |
| hair structure without damaging it, as well as | | | | hairs at once, so you will not use effective heat, |
| products protect the hair during this process. Not only | | | | outer hair strand is heated, while those in the middle, |
| is there to smooth plates of different sizes, but | | | | not much. Also, if you try to smooth a too thick tuft |
| there are also those can leave your hair silky smooth | | | | keeping the iron over time, overheat strands too |
| and completely in a few minutes. | | | | close to the plate and so you can damage them. |
| With new tools ranging in price from about 25 to | | | | There is also the danger of damaging and burning hair |
| about 120 euros, or more, you can make loops or | | | | when using an iron too hot. Always check the level |
| smoothing that want. | | | | of heat if you do not know well the device. Take a |
| But some important rules you should know before | | | | damp paper towel and place it between the springs. |
| using these devices to make the best possible | | | | In principle, the moisture would that evaporate |
| benefits and minimize possible damage. Here are | | | | quickly without burning the tissue. If the paper begins |
| some simple rules for thermal hairstyles: | | | | to wrinkle or fade, low temperature before |
| One: any thermal process starts with the hair clean | | | | proceeding the iron through your hair. |
| and dry . If possible, you should start session with a | | | | Divide your hair in tufts, no larger than your curling |
| hair washing and fortifying a product, both with a | | | | iron and no thicker than half of the iron. Working with |
| moisturizing formula. It also adds a spray product | | | | small sections fine, you apply the heat better and |
| protect the hair during drying and during heat styling. | | | | you can get the desired stiffness from the plate less |
| A cluster of gel, mousse or styling spray before you | | | | often. |
| will look tacky and dense, and may damage your hair, | | | | Four: Use a little hair product application to extend |
| so which it can be washed thoroughly before they | | | | the life of your hairstyle. Applying a some hairspray in |
| are submitted for thermal process. Also, your hair | | | | the strands that you are leaving them smooth and |
| must be completely dry. Not only slightly damp hair | | | | dry well or using a little gel or mousse while dry get |
| will not react well to treatment, but also literally be | | | | straight hair that will stay longer. This is another good |
| cooked in a bath steam, which will break off and | | | | reason to wash and fortify the hair before |
| leave their protective hydration shell. | | | | treatment, it is absolutely necessary to avoid piling up |
| Two: Use proper size tools. If your hair reaches your | | | | of new products on the oldest of the previous |
| shoulders, you must choose a plate having a length | | | | hairstyles. |
